Where technology and gadgets come together and play

Heatsink Lapping for Better Thermal Efficiency

A little elbow grease can help lower CPU temperatures

Written By on in Hardware

320 words, estimated reading time 2 minutes.

In order to get the best from a CPU cooler, it is important to have as much of it contact with the CPU heat spreader as possible. This guide shows you how to get the most from your heat sink.

Thermal compounds help improve themal efficiency of a heatsinks rough surface by 'filling' in the cracks with a highly heat conductive material but to have even better cooling the extreme modder makes sure that both surfaces are as flat as possible. The process of flattening out a cooler is called heatsink lapping.

Why lap a heatsink?

  1. Heatsink lapping or sanding can greatly decrease heat when over clocking.
  2. Heatsink lapping is relatively safe and if you have the correct sandpaper, it's free..
  3. I said its free and it reduces heat from the CPU. Do I need to say more?
Rough, uneven surface of heatsink
Rough, uneven surface of heatsink
Splatter pattern of thermal compound
Splatter pattern of thermal compound

Firstly a before picture, you can see in the reflection that the surface is curved (not flat) and on closeup, you can see little ridges where it has been machined. These ridges and troughs prevent good contact with the CPU. On the second picture, you can see the 'splatter' pattern, where the thermal compound makes good contact and where it makes poor contact.

This is not a how-to article, there are loads of good tutorials on this on the internet - we don't need another one. This is just my experience of it.

After about 10 minutes of sanding with 300 grit sandpaper, I used 600 for another 10, then moved to 1200 grit. Finally I used metal polish. When that was all done, I cleaned the surface with isopropanol to remove all trace of the polish (which is a very good heat insulator). The results:

Finished - a highly polished surface
Finished - a highly polished surface
Almost perfect reflection of house opposite
Almost perfect reflection of house opposite

Notice the reflection, how clear and undistorted it is. That is because the surface is like a mirror now. So shiny I can take pictures of the house opposite on the surface!

Performance wise it reduced my temperatures (as recorded by MBM5) from 49C idle to 48C, and 65C load to 60C. Well worth the effort in my opinion.

Last updated on: Saturday 17th June 2017

 

Comments

There are no comments for this post. Be the first!

 

Leave a Reply

Your email address will not be published.





If you find something abusive or that does not comply with our terms or guidelines please flag it as inappropriate.

Copyright © 2001-2018 Tim Trott, all rights reserved. Web Design by Azulia Designs

This web page is licensed for your personal, private, non-commercial use only.

Disclaimer, Privacy & LegalSitemapContact Me